Name: Pioneer GM-X574
Brand: Pioneer
SKU: 81319
Rating: 62 (1 reviews)

매뉴얼Pioneer GM-X574

Setting the Unit

Gain Control

Adjusting the gain controls A and B willhelp match the output of the car stereo tothe Pioneer amplifier. Normally, set thegain controls to the “NORMAL” posi-tion. If the output is low, even when thevolume of the car stereo is turned up,turn these controls clockwise. If there isdistortion when the volume of the carstereo is turned up, turn these controlscounter-clockwise.

• If you only use one input plug, set the gain

controls for speaker outputs A and B to the

same position.

• When using with an RCA equipped car

stereo (standard output of 500 mV), set to

the NORMAL position. When using with

an RCA equipped Pioneer car stereo with

max. output of 4 V or more, adjust level to

match the car stereo output level.

• If you hear too much noise when using the

speaker input terminals, turn the gain

control counter-clockwise.

Power Indicator

The power indicator lights when thepower is switched on.

LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch

Set the LPF/HPF select switch as follows according to the type of speaker that is connectedto the speaker output connector and the car stereo system:LPF/HPF Select Audio frequency range Speaker RemarksSwitch to be output Type

LPF (Left) Very Low Frequency range Subwoofer Connect a subwoofer.

OFF (Center) Full range Full range

HPF (Right) Low Frequency range to Full range Use if you want to cut the

High Frequency range very low frequency range

because it is not necessary

for the speakers you are

using.

BFC (Beat Frequency Control) Switch

If you hear a beat while listening to anAM broadcast with your car stereo,change the BFC switch using a small standard tip screwdriver.Thank you for purchasing this PIONEERproduct. Before attempting operation, besure to read this manual.

Composition of Manual

This manual applies to the GM-X574 andGM-X374. However, the illustrations showthe GM-X574.

In case of trouble

When the unit does not operate properly,contact your dealer or the nearest autho-rized PIONEER Service Station.

WARNING

• Always use the special red battery and ground

wire [RD-223], which is sold separately. Connect

the battery wire directly to the car battery positive

terminal (+) and the ground wire to the car body.

• Do not touch the amplifier with wet hands.

Otherwise you may get an electric shock. Also, do

not touch the amplifier when it is wet.

• For traffic safety and to maintain safe driving

conditions, keep the volume low enough so that

you can still hear normal traffic sound.

• Check the connections of the power supply and

speakers if the fuse of the separately sold battery

wire or the amplifier fuse blows. Detect the cause

and solve the problem, then replace the fuse with

another one of the same size and rating.

• To prevent malfunction of the amplifier and

speakers, the protective circuit will cut the power

supply to the amplifier (sound will stop) when an

abnormal condition occurs. In such a case, switch

the power to the system OFF and check the

connection of the power supply and speakers.

Detect the cause and solve the problem.

• Contact the dealer if you cannot detect the cause.

• To prevent an electric shock or short-circuit

during connection and installation, be sure to

disconnect the negative (–) terminal of the battery

beforehand.

• Confirm that no parts are behind the panel when

drilling a hole for installation of the amplifier. Be

sure to protect all cables and important equipment

such as fuel lines, brake lines and the electrical

wiring from damage.

Before Using This Product

Input Select Switch

For two-channel input, slide this switchto the left. For four-channel input, slidethis switch to the right.PIONEER CORPORATION

4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN

PIONEER ELECTRONICS (USA) INC.

P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.

TEL: (800) 421-1404

PIONEER EUROPE NV

Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium

TEL: (0) 3/570.05.11

PIONEER ELECTRONICS ASIACENTRE PTE. LTD.

253 Alexandra Road, #04-01, Singapore 159936

TEL: 65-6472-1111

PIONEER ELECTRONICS AUSTRALIA PTY. LTD.

178-184 Boundary Road, Braeside, Victoria 3195, Australia

TEL: (03) 9586-6300

PIONEER ELECTRONICS OF CANADA, INC.

300 Allstate Parkway, Markham, Ontario L3R OP2, Canada

TEL: (905) 479-4411

PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.

San Lorenzo 1009 3er. Piso Desp. 302

Col. Del Valle Mexico, D.F. C.P. 03100

TEL: 55-5688-52-90

Published by Pioneer Corporation.

Publicado por Pioneer Corporation.

Printed in U.S.A.

Impreso en los EE.UU.

<HRD0224-A> ES<KYMFX/02I00000>

BRIDGEABLE FOUR-CHANNEL

POWER AMPLIFIER

AMPLIFICADOR DE POTENCIA DE

CUATRO CANALES EN PUENTE

Owner’s Manual

GM-X574

GM-X374

Manual del Propietario

여기에서 Pioneer GM-X574에 대한 매뉴얼을 무료로 보십시오. 이 매뉴얼은 카테고리 수신기에 속하며 6.2 평균을 가진 1 사람들의 평가를 받았습니다. 이 매뉴얼은 다음 언어로 제공됩니다: 영어. Pioneer GM-X574에 대해 질문이 있습니까? 아니면 도움이 필요하십니까? 여기에 질문하십시오.

도움이 필요하십니까?

Pioneer 에 대해 질문이 있고, 그에 대한 답을 설명서에서 찾을 수 없나요? 여기에서 질문하십시오. 문제와 귀하의 질문에 대한 명확하고 포괄적인 설명을 제공하십시오. 귀하의 문제와 질문에 대해서는 다른 Pioneer 소유자가 더 쉽게 좋은 답변을 제공할 수 있습니다.

질문 수: 0